F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
Removal
NOTE: It is recommended that this component be serviced with the vehicle body removed. If the body cannot be removed, refer to Fuel Injection Pump
Supply Tube - Body On See: Fuel Injection Pump Supply Tube - Body On.
1. Shut the engine off and wait 5 minutes, to allow the fuel in the fuel filter module to partially drain.
2. NOTICE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. To prevent fuel system damage, it is
essential that absolute cleanliness is observed when working with these components.
Remove the cover and, using a suitable suction device, remove the fuel from the fuel filter module.
-
Install the cover when finished.
-
Tighten to 27 Nm (20 lb-ft).
3. Remove the vehicle body.
4. Loosen the exhaust downpipe-to-turbocharger clamp.
5. Remove the 2 exhaust downpipe-to-Oxidation Catalytic Converter (OC) bolts and remove the exhaust downpipe from the vehicle.
-
Discard the clamp and gasket.
6. Disconnect the Exhaust Gas Recirculation Temperature (EGRT) sensor electrical connector.
