F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
Removal and Installation
NOTICE: Position a suitable protective material in front of the Charge Air Cooler (CAC) or damage to the CAC can occur.
1. Loosen the RH Charge Air Cooler (CAC) tube clamps and disconnect the CAC tube from the flex hoses.
-
To install, tighten to 8 Nm (71 lb-in).
2. Remove the side bolt for the fuel cooler radiator.
-
To install, tighten to 7 Nm (62 lb-in).
3. Remove the 2 bolts for the CAC.
-
To install, tighten to 22 Nm (16 lb-ft).
4. Remove the 4 radiator support clamp bolts and the 2 radiator support clamps.
-
To install, tighten to 10 Nm (89 lb-in).
5. Remove the 2 radiator isolators.
6. Disconnect the horn assembly electrical connector, the hood latch release cable position retainer and if equipped, disconnect the fog light electrical
connector position retainer.
7. Remove the bolt and the horns.
8. If equipped, disconnect the temperature sensor pushpin and position aside.
