F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
5. Install the air cleaner element.
6. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.
See: Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
7. NOTE: If the Instrument Cluster (IC) or the PCM (or both) is being replaced, the parameters must be reset in both modules or the vehicle will
experience a Passive Anti-Theft System (PATS) no start. This will occur even if the vehicle is not equipped with PATS.
Carry out the PATS Parameter Reset. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and
Inspection/Programming and Relearning/Passive Anti-Theft System (PATS) Parameter Reset
Vehicles with Circuit Deactivation Ignition Module (CDIM)
8. Carry out the extended idle shut down initialization procedure. For additional information, refer to Extended Idle Shutdown Initialization See:
Procedures procedure.
