F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
Fuel Temperature Sensor: Service and Repair
Fuel Temperature Sensor
NOTE: Vertical EGR cooler and bracket removed for clarity.
Removal and Installation
1. NOTICE: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be
damaged.
Turn the ignition switch to the OFF position.
2. Remove the cooling fan stator.
3. Disconnect the fuel temperature sensor electrical connector.
4. NOTE: Use a 12-point deep well (hollow) socket to remove and install the fuel temperature sensor. Some deep well sockets narrow at the ratchet
end are not deep enough to be used for this procedure.
Remove the fuel temperature sensor. Remove and discard the O-ring seal.
-
To install, tighten to 18 Nm (159 lb-in).
