F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
15. Loosen the 2 transmission insulator nuts.
16. Disconnect the exhaust pipes.
17. Lift the right side of the engine approximately 38.1 mm (1.5 in).
18. Disconnect the rear transmission fluid cooler tubes from the transmission case and remove them from the vehicle.
Installation
1. Install the rear transmission fluid cooler tubes into the vehicle and connect the transmission fluid cooler tubes to the transmission case.
-
Tighten to 40 Nm (30 lb-ft).
2. Lower the engine.
3. Connect the exhaust pipes.
-
Tighten to 40 Nm (30 lb-ft).
4. NOTE: The transmission insulator studs may have been removed with the nuts, install if necessary.
Tighten the transmission insulator nuts.
-
Tighten the studs to 75 Nm (55 lb-ft).
-
Tighten the nuts to 115 Nm (85 lb-ft).
