F 350 2WD Super Duty V8-6.4L DSL Turbo (2009)
5. Install the 3 LH engine mount nuts.
-
Tighten to 172 Nm (127 lb-ft).
6. Install the 4 RH engine mount nuts.
-
Tighten to 115 Nm (85 lb-ft).
7. Remove the Engine Support Bracket and Support Hook.
8. NOTE: If equipped with dual generators, install the upper generator.
Remove the Engine Lifting Bracket.
9. NOTICE: Only use banjo bolts with a green hex head. Failure to install the correct banjo bolt may result in damage to the turbocharger.
NOTE: Use a backup wrench to prevent the fittings from turning.
Install new copper sealing washers and banjo bolts on the turbocharger oil feed fittings.
-
Tighten to 38 Nm (28 lb-ft).
-
Move the turbocharger actuator linkage through the full range of motion and verify that the turbocharger oil supply tube does not contact the
turbocharger actuator linkage.
