ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Relays and Modules - Transmission and Drivetrain > < Engine Controls - MIL ON/Nitrous Oxide Monitor DTC's Set
Page 1
background image

Relays and Modules - Emission Control Systems: All Technical Service Bulletins
Engine Controls - MIL ON/Nitrous Oxide Monitor DTC's Set

TSB 10-19-7

10/11/10

6.7L DIESEL - MIL ON - DTCS P207F, P20EE, P2200 
AND/OR P2201 - BUILT ON OR BEFORE 6/2/2010

FORD:
2011 F-250, F-350, F-450, F-550

ISSUE
Some 2011 F-Super Duty vehicles equipped with a 6.7L engine and built on or before 6/2/2010 may exhibit malfunction indicator lamp (MIL) on with
diagnostic trouble codes (DTCs) P207F, P20EE, P2200 or P2201 and may indicate the vehicle is operating in a derate mode and may experience a loss
of power.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

1. Perform visual inspection of Nitrogen Oxides (NOx) module wiring, NOx module and NOx sensor for damaged wire harness, connectors and/or

incorrect wire harness routing.

a. If no damage or wiring concerns are present, proceed to Step 2.

b. If damage is found do not proceed with this article and follow normal Workshop Manual (WSM) diagnostics.

2. Replace the NOx sensor.

Parts Block

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

101907A

2011 F-Super Duty 6.7L:

0.6 Hr.

Check DTCs, Inspect
Wiring, And Replace The
NOx Sensor (Do Not Use
With Any Other Labor
Operations)

DEALER CODING

CONDITION

BASIC PART NO.

CODE

9D378

49

Disclaimer

Relays and Modules - Transmission and Drivetrain > < Engine Controls - MIL ON/Nitrous Oxide Monitor DTC's Set