F 350 4WD Pickup V8-351 5.8L VIN G 2-bbl (1985)
2. Clean the mating surfaces of the intake manifold, cylinder heads and cylinder block using a solvent such as Ford Spot Remover or equivalent.
Apply a 3.2 mm (1/8 inch) bead of RTV sealer, at the points shown.
3. Apply a 1.6 mm (1/16 inch) bead of RTV sealer to the outer end of each intake manifold seal for the full width of the seal (4 places).
NOTE: This sealer sets-up in 15 minutes, so it is important that assembly be completed promptly. Do not drip any sealer into the engine valley.
Position the seals on the cylinder block and new gaskets on the cylinder heads with trademark towards cylinder head with the gaskets interlocked
with the seal tabs. Be sure the holes in the gaskets are aligned with the holes in the cylinder heads.
4. Carefully lower the intake manifold into position on the cylinder block and cylinder heads.
NOTE: After the intake manifold is in place, run a finger around the seal area to make sure the seals are in place. If the seals are not in place,
remove the intake manifold and position the seals.
