F 350 4WD Pickup V8-351 5.8L VIN G 2-bbl (1985)
1.
Remove axle shaft as outlined in ``Axle Shaft, Replace''.
2.
Insert tool T83T-1226-A for models with 8.8 inch ring gear, or tool T85T-1225-AH for models with 10.25 inch ring gear, and tool T50T-100-A
into axle bore so tangs on tool engage bearing outer race. Remove bearing and seal as an assembly.
3.
Install new bearing using tool T83T-1225-B on models with 8.8 inch ring gear, or tool T80T-4000-W on models with 10.25 inch ring gear, and
new seal using tool T83T-1175-A on models with 8.8 inch ring gear, or tool T80T-4000-Y on models with 10.25 inch ring gear. Pack lips of seal
with C1AZ-19590-B or equivalent.
4.
Reinstall axle.
Ford Removable Carrier Type
Removal, Units w/Ball Bearing
1.
Remove wheel assembly.
2.
Remove brake drum from flange.
3.
Working through hole provided in axle shaft flange, remove nuts that secure wheel bearing retainer.
4.
Pull axle shaft out of housing. If bearing is a tight fit in axle housing, use a slide hammer type puller.
5.
Remove brake backing plate and secure to frame rail.
6.
If the axle shaft bearing is to be replaced, loosen the inner retainer by nicking it deeply with a chisel in several places. The bearing will then slide
off easily.
7.
Press bearing from axle shaft.
8.
Inspect machined surface of axle shaft and housing for rough spots that would affect sealing action of the oil seal. Carefully remove any burrs or
rough spots.
Installation
1.
Press new bearing on shaft until it seats firmly against shoulder on shaft.
2.
Press inner bearing retainer on shaft until it seats firmly against bearing.
3.
If oil seal is to be replaced, use a hook-type tool to pull it out of housing. Wipe a small amount of oil resistant sealer on outer edge of seal before it
is installed.
Removal, Units W/Roller Bearing
1.
Remove wheel assembly.
2.
Remove brake drum from flange.
3.
Working through hole provided in axle flange, remove nuts securing wheel bearing retainer.
4.
Pull axle shaft carefully from housing to prevent damage to outer seal rubber. Use a slide hammer type puller to remove tapered bearing cup from
housing. Remove brake backing plate and secure to frame rail.
5.
If the axle shaft bearing or seal is to be replaced, split the inner bearing retainer.
6.
Press bearing from axle shaft.
7.
Inspect machined surface of axle shaft and housing for rough spots that would affect sealing action of the oil seal. Carefully remove any burrs or
rough spots.
8.
Install outer retainer plate on axle shaft. Press lubricated seal and bearing onto shaft until firmly seated. Oil seal for rear drum brake equipped
vehicles is different than that used on vehicles with rear disc brakes. Seals used with drum brakes have a gray metal colored outer rim,
while seals used with disc brakes have a black or orange color.
9.
Press new bearing retainer onto shaft until seated.
Installation
1.
On 1980---84 models, place a new gasket on each side of brake carrier plate, and slide axle shaft into housing. On models with roller bearing,
ensure outer seal is fully seated on bearing.
2.
Start splines into differential side gear and push shaft in until bearing bottoms in housing.
3.
Torque bearing retainer nuts to 20---40 ft. lbs.
