F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Antenna - Keyless Entry: Service and Repair
REMOVAL
This vehicle uses a PIA-type antenna. DO NOT remove existing antenna from wire harness. The antenna is taped to the wire harness connected to
the remote entry module.
1. Disconnect antenna connector from remote entry receiver module and tape securely out of the way.
INSTALLATION
1. Connect new antenna connector to remote entry receiver module.
2. Install new PIA-type antenna into vehicle, taping along wire harness path followed by old (unconnected) PIA antenna. Secure using approved
tie-wrap or tape.
