F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
11.
Plug in fog lamp wiring and push pins for the block heater connector and lower valance push pins.
12.
Lower vehicle and turn on air suspension if so equipped.
13.
Clean vent and fog lamp openings as needed.
1997-98 F-150/250 LD 4X2 Front Bumper
1997-98 F-150/250 LD 4X2 FRONT BUMPER
1.
Turn off air suspension it applicable.
2.
Hoist vehicle until bumper is at working level.
3.
Clean excessive dirt from inside and outside the bumper.
4.
Remove the five (5) push pins to the radiator support.
5.
Spray the edges of the air intake opening and the bumper cover retainer openings and drain holes with Super Seal Anti-Corrosion Compound.
6.
Reinstall the push pins and remove the tape.
7.
Lower vehicle and turn on air suspension if so equipped.
8.
Clean off overspray as needed.
1997-98 F-150/250 LD Rear Bumper (4X2/4X4)
1997-98 F-150/250 LD REAR BUMPER (4X2 AND 4X4)
1.
Turn off air suspension if applicable.
2.
Hoist vehicle until bumper is at working level.
3.
Clean excessive dirt from inside and outside the bumper.
4.
Spray the back of the bumper from underneath the vehicle. Make sure to spray the license plate lights, openings, and the bumper pad retaining
holes with Super Seal Anti-Corrosion Compound.
5.
Lower vehicle and turn on air suspension if so equipped.
6.
Clean off overspray as needed.
1990-97 F-250 HD/F-350/Bronco Frnt./Rear Bumper
1990-97 F-250 HD/F-350/BRONCO - FRONT BUMPER
1.
Hoist vehicle until bumper is at working level.
2.
Remove the lower valance out of the way to allow access to inside of front bumper.
3.
Clean excessive dirt from inside and outside the bumper.
4.
Tape license plate bolt holes.
5.
Spray the edge of the opening and the bolt opening area including the license plate lights bracket holes with Super Seal Anti-Corrosion
Compound.
6.
Reinstall lower valance.
7.
Remove protective tape.
8.
Lower vehicle.
9.
Clean off overspray as needed.