F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
4.
Mask the front face of the center at air opening and both fog lamp openings (Figure 1).
5.
Disconnect fog lamp wiring and block heater wires from the bumper.
6.
Disconnect the three (3) push pins for the splash guard.
7.
Clean excessive dirt from inside and outside the bumper.
8.
Spray the edges of the three (3) openings with Super Seal Anti-Corrosion Compound.
9.
Remove the tape from the fog lamp openings so as not to get the Super Seal Anti-Corrosion Compound on the fog lamps during reinstallation.
10.
Reinstall the fog lamps/fog lamp blanks.
