F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Power Mirror Motor: Service and Repair
REMOVAL
1. Remove the glass assembly. Mark the motor with tape or grease pencil to indicate top of motor.
2. Remove the four screws retaining the motor to the mirror body.
3. Pull motor away from the mirror body.
4. Remove the plastic cover plate from the back of the motor. Pull off by hand.
5. Use masking tape on the wires. Mark on the wire its location in the motor with the terminal number on the motor where the wires plug in.
6. Carefully pull the wires/terminals out of the motor.
INSTALLATION
1. Install wires into the motor by matching the terminal number marked on the wires and on the motor. Remove masking tape from the wires.
2. Make sure wires are placed in the retaining slots in back of motor, then align the opening in the plastic cover plate with the wires on the back of
motor and push on back cover.
3. Make sure the rubber seal is properly installed on the motor.
4. Position motor in mirror body using the mark (added during removal) indicating top of motor and line up the four screw holes.
5. Install the four screws and hand-tighten. Do not overtighten.
6. Install the glass assembly.
