F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
INSTALLATION
1. Clean and inspect the mounting faces of the lower and upper intake manifolds.
CAUTION: Do not use solutions such as brake cleaner, carburetor cleaner, etc., as these solutions can leave a residue on the machined surfaces.
Use only a cleaner which meets or exceeds Ford specification WSE-M5B392-A, such as Metal Surface Cleaner F4AZ-19A536-RA or equivalent.
2. Position new gasket on lower intake mounting face. The use of alignment studs may be helpful.
3. Install upper intake manifold and throttle body assembly to lower intake manifold, making sure gasket remains in place (if alignment studs are not
used).
4. Position EGR transducer. Install two nuts and tighten to 17-24 Nm (13-18 ft. lbs.).
5. Connect electrical connector to EGR transducer.
6. Connect EGR transducer hoses to EGR tube.
7. Install six upper intake manifold retaining bolts and tighten to 17-24 Nm (13-18 ft. lbs.).
8. Install upper intake support bracket to upper manifold attaching bolt.
