F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
2. When removing ignition coil to distributor high tension wiring or distributor to spark plug wire from distributor cap or ignition coil, grasp boot by
hand and remove with twisting motion.
INSTALLATION
NOTE: Whenever any ignition wiring equipped with a boot is removed or installed, Silicone Brake Caliper Grease and Dielectric Compound
D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A must be applied to boot before it is reconnected.
1. Using a small clean tool, coat entire interior surface of boot with the specified dielectric compound.
2. Insert each distributor to spark plug wire and ignition coil to distributor high tension wiring on proper terminal of distributor cap. Make sure
distributor to spark plug wires and ignition coil to distributor high tension wiring are properly installed on their terminals. The number 1 terminal
is identified on distributor cap. Install distributor to spark plug wires and ignition coil to distributor high tension wiring starting with number 1
terminal.
3. Remove ignition wire separators from old spark plug wire set and install them on new set in same relative position. Install distributor to spark plug
wires and ignition coil to distributor high tension wiring in ignition wire separators on valve cover.
4. Connect distributor to spark plug wires to proper spark plugs.
5. Install ignition coil to distributor high tension wiring to the distributor cap.
