F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
5. Tighten the puller forcing screw to pull the A/C clutch field coil from the compressor head.
CAUTION: Do not use air tools.
INSTALLATION
1. Clean the mounting surface on the front head to remove any dirt or corrosion.
2. With the A/C compressor in a vertical position (nose up), place the A/C clutch field coil in position on the compressor front head. Make sure the
coil electrical connector is positioned correctly.
3. Place Field Coil Replacer T91L-19623-CH in position centered over the A/C clutch field coil.
4. Place the Coil Pressing Tool T89P-19623-EH in position over the compressor nose and to the inner radius of the A/C clutch field coil.
5. Position 2-Jaw Puller D80L-1002-L or equivalent on the A/C compressor and the coil pressing tool. The jaws of the puller should be firmly
engaged with the rear side of the compressor front mounts. The forcing screw must be piloted on the center mark of the pressing tool.
6. Tighten the forcing screw with a hand wrench until the A/C clutch field coil is pressed on the compressor front head. Check to make sure that the
A/C clutch field coil bottoms against the head at all points around the outer diameter.
CAUTION: Do not use air tools.
7. Install the clutch pulley and hub on the A/C compressor. Adjust the air gap as necessary. See: Compressor Clutch/Adjustments
8. Install the A/C compressor on the vehicle.
