F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Distributor Cap: Service and Repair
REMOVAL
1. Disengage spring clips.
2. Lift distributor cap with attached wire set straight off distributor to prevent damage to the rotor blade and spring. To remove base adapter, loosen
retaining screws.
INSTALLATION
1. Inspect distributor cap.
2. Replace the distributor cap if damage is found.
3. Reinstall any ignition wires removed in their proper locations.
4. If removed, position base adapter and tighten retaining screws to 2.8-4.0 Nm (25-35 lb in).
5. Position spring clips and press inward on center of clips until they snap into place on distributor cap.
