F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
2. Remove the wheel and tire assembly.
3. Remove the brake drum from the axle shaft or lug bolts.
CAUTION: Never use a hammer to remove the stud. Damage to the hub or bearing can result.
C-Fram And Clamp Assembly
4. Using C-Frame and Clamp Assembly T74P-3044-A1, press the lug bolt from its seat in the rear hub. The lug bolt can also be removed by pressing
it out using an appropriate sized socket and C-clamp. Discard the lug bolt.
INSTALLATION
1. Insert new wheel hub bolt in hole in axle shaft or rear hub. Rotate lug bolt slowly, aligning serrations with those made by the original lug bolt.
Lug Nut
2. Place four flatwashers over the outside end of the lug bolt and thread the lug nut with the flat side against the washers.
CAUTION: Do not use air tools; serrations can be stripped from the stud.
3. Tighten the lug nut until the lug bolt head seats against the back side of the shaft or hub.
4. Remove lug nut and washers.
5. Install brake drum and wheel.
6. Lower the vehicle and test brakes.
Rear
CAUTION: Never use a hammer to remove the wheel hub bolt nut. Damage to the axle shaft flange or rear wheel bearing can result.
REMOVAL
1. Raise the vehicle and install safety stands.
2. Remove the wheel and tire assembly.
