F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
8.
Inspect the rear linings for wear or glazing. If the linings show excess wear or glazing, then replace the rear brake shoe and lining assemblies. If
the linings have enough material, hand sand them using garnet paper 100A (medium grit) or aluminum oxide 150J (medium grit).
9.
Adjust the rear brakes by referring to the Service Manual, Section 06-02. Check the self-adjusters to make sure they are working properly.
10.
Check the rear shock absorbers.
^
Disconnect the lower end of the rear shock absorbers
^
Extend and compress the shock absorbers as fast as possible, using as much travel as possible. The action should be smooth and uniform
throughout each stroke. Faint swish noises and higher resistance on extension than on compression are normal conditions. Service as required.
Refer to the Service Manual, Section 04-00, for additional information.
11.
Torque the lug nuts on the vehicle per Step 2.
12.
Re-evaluate the vehicle for brake shudder.
OTHER APPLICABLE ARTICLES: 98-5A-27, 98-5A-35, 98-5A-4
SUPERSEDES: 97-23-8
WARRANTY STATUS: INFORMATION ONLY OASIS CODES: 301000, 703000, 703400
