F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Alignment: Service and Repair
Toe
The steering linkage has adjustments at the tie rod end. First, remove the horn pad and make sure the steering wheel is installed properly. With steering
wheel locked in place, set toe to correct specification.
1. Loosen the clamp bolts for the adjusting sleeve.
2. Rotate the sleeve until the correct toe alignment is obtained.
3. With the clamps 4.76 mm (3/16 inch) from the end of the sleeve and centered between the adjusting sleeve lock ring protrusions, position the
bolts as described below.
a. After setting toe, the two clamp bolts/nuts on each adjusting sleeve must be positioned within a limit of 45 degrees (plus/minus) as shown with
the threaded end of the bolts on the left-hand sleeve pointing toward the front of the vehicle and the threaded end of the bolts on the right-hand
sleeve facing rearward.
b. After setting toe, the clamp bolt/nut on the left (drag link) adjusting sleeve must be positioned within a limit of 45 degrees (plus/minus) as
shown with the threaded end of the bolt pointing forward.
NOTE: Lubricate clamp fasteners prior to tightening.
4. Recheck the toe alignment to make sure no changes occurred as the clamp nuts were tightened.
