F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
2. Position the front suspension lower arm ball joint, U-Joint Tool T74P-4635-C, Receiver Cup T80T-3010-A3 and Ball Joint Remover/Replacer
T92T-3010-B inside of Ball Joint Remover/Replacer T92T-3010-A on the knuckle to force ball joint into position.
3. Turn the forcing screw clockwise until the front suspension lower arm ball joint bottoms in the bore. Remove the tools.
4. Install the snap ring on the front suspension lower arm ball joint.
5. Assemble the knuckle to the tube yoke. Install the camber bushing, if previously removed. Install the retaining nut of the front suspension upper
ball joint. Do not tighten at this time.
6. Install the retaining nut of the front suspension lower arm ball joint.
7. Tighten both retaining nuts as follows:
a. Tighten nut of the front suspension lower arm ball joint to 47 Nm (35 ft. lbs.).
b. Tighten nut of the front suspension upper ball joint to 95 Nm (70 ft. lbs.).
c. Advance nut of the front suspension upper ball joint to next castellation, and install new cotter pin.
d. Retighten nut of the front suspension lower arm ball joint to 203 Nm ( 150 ft. lbs.).
