F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
REMOVAL
1. Remove the drive belt.
2. On some vehicles, it may be necessary to remove the fan shroud to allow for proper installation and operation of the power steering pump pulley
remover tool.
3. Install Steering Pump Pulley Remover T69L-10300-B on the hub of the power steering pump pulley.
4. While holding the nut of the remover tool stationary with a wrench, rotate the inner spindle of the remover tool clockwise until the power steering
pump pulley is pulled off the power steering pump rotor shaft.
CAUTION: Do not apply pressure on the power steering pump rotor shaft. Pressure will damage internal thrust areas of the power steering pump.
INSTALLATION
1. Place the power steering pump pulley on the power steering pump rotor shaft.
2. Screw stud of the Steering Pump Pulley Replacer T65P-3A733-C into end of power steering pump rotor shaft.
3. While holding the inner spindle of the replacer stationary with a wrench, rotate the nut of the replacer tool clockwise until the pulley hub is flush
within +0.25 mm (0.010 inch) of the end of the power steering pump rotor shaft.
4. Remove the replacer tool and verify that the hub is flush with the end of the power steering pump rotor shaft.
5. If hub has been installed too far onto the power steering pump rotor shaft, pull back slightly using Steering Pump Pulley Remover T69L-10300-B.
6. Install the fan shroud.
7. Install drive belt.
8. Start engine and listen for belt "chirp." If the belt makes a chirping noise, repair or replace as necessary.
