F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
DISASSEMBLY
1. With worm shaft removed, remove the dust seal from the valve housing using Puller T58L-101-B and Impact Slide Hammer T59L-100-B. Discard
the seal.
2. Remove the snap ring from the valve housing
3. Turn Bench Mounted Holding Fixture T57L-500-B to invert valve housing.
4. Insert Seal Replacer T65P-3524-A2 and Driver Handle T65P-3524-A3 in the valve housing opposite the oil seal end, and gently tap the power
steering gear input shaft bearing and seal out of the housing. Discard the seal.
CAUTION: Do not damage the housing when inserting and removing the tools.
5. If they are damaged, remove the fluid inlet and outlet tube seats with Brass Tube Seat Remover T74P-3504-L.
ASSEMBLY
1. Coat the fluid inlet and outlet tube seats with petroleum jelly or equivalent. install seats in the housing with a Brass Tube Seat Replacer
T74P-3504-M.
2. Coat the bearing and seal surface of the steering gear housing with petroleum jelly or equivalent.
