F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
NOTE: The front case bushing has three lube grooves. The rear case bushing has one lube groove.
8. Set portion of tool with front case bushing and drawbar into bushing bore from the front as shown in the illustration.
9. Place the remaining portion of Rear Case Bushing Replacer T92T-77110-AH into the rear bushing in the case as a guide. Install washer and nut
and hand-tighten.
CAUTION: Make sure the bushing and tool are centered in the bore.
10. Hold the drawbar with a 1/2-inch wrench, while turning the nut with a 1-1/8-inch wrench as shown.
a. Turn the nut until the front case bushing is fully seated.
b. Unscrew the nut and remove all tools.
