F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
11. Remove 11 accumulator body bolts using an 8 mm socket and two nuts using a 10 mm socket. Remove accumulator body assembly.
12. If valve body separator plate is to be left on the transmission, remove and install one of the reinforcing plate bolts into any of the case threaded
bolt holes on the opposite end of the separator plate. This will prevent the valve body separator plate from sagging and displacing check balls.
13. Remove 14 main control valve body bolts using an 8 mm socket and two nuts using a 10 mm socket. Remove main control valve body.
NOTE: Do not remove the two bolts as shown in the following illustration. This will keep the upper and lower main control valve bodies attached
as an assembly.
14. Remove nine solenoid body assembly bolts using a T30 Torx bit and one nut using a 10 mm socket. Push down on solenoid body assembly
receptacle to remove solenoid body assembly.