F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
5. Clamp the bearing in a vise and tap on the driveshaft center yoke to free it from the bearing.
6. Lift the two bearing cups from the spider.
7. Reposition the tool on the driveshaft center yoke and move the remaining bearing in the opposite direction so that it protrudes approximately 9.525
mm (3/8 inch) out of the driveshaft center yoke.
8. Clamp the bearing in a vise. Tap on the driveshaft center yoke to free it from the bearing.
9. Remove the spider from the driveshaft center yoke.
10. Pull the driveshaft centering socket yoke off the center stud. Remove the rubber seal from the centering ball stud.
11. Remove the snap rings from the driveshaft center yoke and from the driveshaft yoke.
