F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
6. Lightly coat the lips of the axle shaft rolling diaphragm seal (RDS) and the mating surface of the front wheel spindle with High Temperature 4x4
Front Axle and Wheel Bearing Grease E8TZ-19590-A or equivalent meeting Ford specification ESA-M1C198-A.
7. Carefully guide the axle shaft through knuckle and into the axle housing. Check that the splines of the axle shaft are engaged in the differential side
gear splines.
8. Install the front disc brake rotor shield on the steering knuckle.
9. Place front wheel spindle on the steering knuckle. Install nuts and tighten to 68-81 Nm (50-60 ft. lbs.).
10. Install the front disc brake hub and rotor on the front wheel spindle, inspecting the wheel bearings and grease seal, and making sure there is
adequate lubrication with High Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-19590-A or equivalent meeting Ford specification
ESA-M1C198-A.
11. Install bearing, lock nuts, and hub locks.
12. Install the disc brake caliper.
13. Install the front wheel and tire.