F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
Flywheel: Service and Repair
Removal and Installation
REMOVAL
1. Remove the transmission and flywheel housing clutch pressure plate and clutch disc.
2. To check flywheel face runout or to replace a flywheel ring gear.
3. Remove the flywheel attaching bolts and remove the flywheel.
INSTALLATION
1. Coat the threads of the flywheel attaching bolts with oil-resistant Threadlock and Sealer EOAZ-19554-AA or equivalent meeting Ford
specification WSK-M2G315-A5 (Type II). Position the flywheel on the crankshaft flange. Install and tighten the bolts in sequence across from
each other to 102-115 Nm (75-85 ft. lbs.).
2. Check the flywheel runout. Install the clutch pressure plate, clutch disc and the transmission and flywheel housing.
