F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
4. Position the oil seal in the case. Using Driver Handle T80T-4000-W and Front Seal Replacer T87T-7025-EH, drive in the oil seal until it seats
against its stop.
CAUTION: If the counter shaft cluster gear, input shaft, mainshaft or one or more tapered roller bearings has been replaced, it is mandatory that
the tapered roller bearings be adjusted to obtain a preload of 0.02 to 0.11 mm (0.00079 to 0.00434 inch).
5. Heat up the mounting bore in the case for the outer race of the output shaft bearing to 160° C (320° F) with Rotunda Heat Gun 107-R0300 or
equivalent.
6. Position the output bearing front shim with proper thickness in the bore. Using Driver Handle T80T-4000-W and Bearing Cup Replacer
T73T-4222-A, drive the output shaft bearing in until it seats against the stop in the case.
7. Heat the case in the area of the bearing of input shaft to 160° C (320° F) with Rotunda Heat Gun 107-R0300 or equivalent.
