F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
5. If required, remove the central shift rail bearing from the extension housing. Use Blind Hole Puller D80L-100-G or equivalent and Impact Slide
Hammer T50T-100-A to remove the bearing.
INSTALLATION
1. If removed, install the central shift rail bearing into the extension housing. Heat the extension housing in the area of the bearing bore to 160° C
(320° F) with Rotunda Heat Gun 107-R0300 or equivalent. Insert the ball sleeve and drive the bearing in until it seats against its stop using Needle
Bearing Replacer T87T-7025-DH and Driver Handle T80T-4000-W.
