F 350 4WD Pickup V8-351 5.8L VIN H EFI (1997)
13. Place 5th gear bearing on the mainshaft.
14. Install the 5th gear on the mainshaft over the 5th gear bearing.
15. Heat the inner race of the output shaft rear bearing to 160° C (320° F) with Rotunda Precision Metal Gear/Bearing Heater 164-R3900 or
equivalent. Place it on the mainshaft and drive it on if necessary until it seats against its stop on the mainshaft.
CAUTION:
-
Do not heat the output shaft rear bearing for more than 15 minutes.
-
If necessary to drive the output shaft rear bearing on, drive against the inner race only. Do not drive against the bearing cone.
