F 350 4WD Pickup V8-7.3L DSL (1988)
10.
Push the "I" beam axle forward until radius arm separates from the radius arm bracket.
11.
Remove and save inner retainer and spacer from radius arm. Discard "wedding band spacer". DO NOT REINSTALL "WEDDING BAND". See
Drawing Attachments 1, 2 and 3.
12.
Install the inner retainer and new front bushing on the radius arm stud and insert the stud through the radius arm bracket.
NOTE: For vehicles with EFI engines, an exhaust heat shield MUST be installed between the outer insulator and washer (right side only). See
Drawing Attachments 2 or 3.
