F 350 4WD Pickup V8-7.3L DSL (1988)
1.
Clean the grease from the column lock actuator and upper flange using parts cleaner (F3AZ-19579-SA) or equivalent, Figure 1.
2.
Apply silicone lubricant (COAZ-19553-AA) or equivalent to the column lock actuator and upper flange where the actuator slides.
3.
Install the column lock actuator into the upper flange.
4.
Install the upper flange onto the outer flange.
5.
Install the steering wheel onto the steering shaft and hand tighten the steering wheel nut.
6.
Pull up on the steering wheel until the steering column expands about 10 mm (0.375").
7.
Remove the steering wheel.
8.
Press the upper bearing onto the steering shaft.
9.
Install a new snap ring (DOAZ-3C610-B) on the steering shaft.
10.
Using a small hammer, gently tap the steering shaft until the upper bearing is seated into the upper flange.
11.
Install the lock cylinder.
12.
Install the turn signal switch and turn signal lever.
13.
Install the ignition switch.
14.
Install the two (2) bolts attaching the steering wheel bracket to the pedal bracket.
15.
Install the steering wheel.
16.
Connect the battery ground cable.
PART NUMBER
PART NAME
COAZ-19553-AA
Silicone Lubricant
F3AZ-19579-SA
Metal Brake Parts Cleaner
DOAZ-3C610-B
Snap Ring
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 91-6-5
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION
DESCRIPTION
TIME