F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Rear Anti-Lock Brake System (RABS) Module: Service and Repair
Anti-Lock Electronic Control Unit
1. Disconnect the wiring harness from the antilock electronic control unit by depressing the plastic tab on the connector and pulling the connector off.
2. Remove the two screws that retain the antilock electronic control unit to the instrument panel. Remove the antilock electronic control unit.
3. For installation, follow removal procedures in reverse order, followed by a system check for proper operation. Tighten screws to 2.1-2.9 N-m
(18-27 ft-lb).
