F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Brake Bleeding: Service and Repair
Manual Bleeding
NOTE: Bleed primary and secondary hydraulic brake systems separately, bleeding longest line first on each system. Do not allow reservoir to run dry
during bleeding operation. Never reuse fluid that has been drained from hydraulic system.
1. Loosen master cylinder to hydraulic line nuts and wrap shop cloths around tubing below fitting to absorb escaping brake fluid.
2. Depress brake pedal slowly forcing air trapped in master cylinder out at fitting.
3. Hold pedal down and tighten fittings, then release brake pedal.
NOTE: Releasing brake pedal before fittings are tightened will allow air to enter the master cylinder.
4. Repeat steps 1 through 3 until air ceases to escape at fittings and brake pedal is firm.
5. Bleed brakes as follows:
RR, LR, ABS valve, RF, LF
a. Pump pedal several times, then hold pedal down firmly.
b. With pedal firmly depressed, open bleeder screw on one rear brake until pedal fades, then close bleeder valve.
c. Repeat procedure until a continuous flow of brake fluid is released from bleeder valve.
d. Repeat steps 5a through 5c on other rear brake.
6. Bleed the Rear Antilock Brake System (RABS) valve.
7. Bleed the front brakes using same procedure as for rear brakes.
8. Fill master cylinder to 1/4 inch from top of reservoir or to the proper fill line indicated on the fluid reservoir.
9. Centralize pressure differential control valve, if applicable, as follows:
a. Turn ignition switch to ACC or ON position.
b. Push brake pedal down, allow piston to center itself, turning off warning light.
c. Turn ignition switch to the OFF position.
10.
Check brake operation and ensure pedal is firm, road test vehicle.
