F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
1. Install the pedal pad on the brake pedal, if required.
2. Install the stoplight switch on the brake pedal bracket.
3. Place brake master cylinder push rod bushing (2474) and washer spring in position on the brake pedal.
4. Install the following:
-
Move the brake pedal into the bracket.
-
Slide the clutch pedal so the clutch and brake pedal pivot shaft goes through the hub of the brake pedal.
-
Install the brake and clutch pedal bushing, clutch rod and lever onto the clutch and brake pedal pivot shaft.
-
Position the nut holding the clutch lever to clutch and brake pedal pivot shaft and tighten.
-
Connect the clutch pedal retracting spring.
