F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
b.
If the wedge has been previously installed as illustrated in Figure 3.
^
If wedge is properly installed, go to PARKING BRAKE FUNCTIONAL TEST.
^
If wedge is not installed as shown in figures, remove wedge as outlined in Steps 1 through 4 of PARKING BRAKE ADJUSTMENT
PROCEDURE, then continue with WEDGE INSTALLATION.
c.
If the wedge is not present or the vehicle is not equipped with the cam-in post design parking brake control assembly, proceed with WEDGE
INSTALLATION.
NOTE:
Previously installed wedges may be translucent rather than white (Bronco/F-Series) or Black (Ranger/Explorer).
Lock-In Wedge Installation
1.
Apply and release parking brake at least six (6) times allowing pedal to return each item without any interference. This will "neutralize" the
parking brake cable system and allow for proper evaluation of the system once the wedge is installed.
2.
Apply foot pressure to the pedal so that the pedal rotates (about 2-1/2" to 3") from the "RELEASED" position. See Figure 4.
WARNING
BE CAREFUL NOT TO ACCIDENTALLY RELEASE THE PARKING BRAKE SPRING LOADED RELEASE ARM DURING THE
INSTALLATION PROCEDURE BY PULLING ANYWHERE ON THIS RELEASE LEVER.
