F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
REMOVAL (Ranger Only)
1.
Disconnect the wiring harness from the anti-lock electronic control module by depressing the plastic tab on the connector and pulling the
connector off.
2.
Disconnect the wiring harness from the intermittent windshield wiper (IWW) module by depressing the plastic tab on the connector and pulling the
connector off.
3.
Remove the screw and nut that retain the anti-lock electronic control module and bracket assembly to the instrument panel. Remove the module
and bracket assembly.
4.
Remove the screws that retain the module to the instrument panel bracket. Remove the module. MUTILATE AND SCRAP THE REMOVED
INCORRECT MODULE.
INSTALLATION (Ranger Only)
1.
Place the correct anti-lock electronic control module in position on the instrument panel bracket. Install and tighten the module retaining screws.
2.
Place the anti-lock electronic control module and bracket assembly in position in the instrument panel. Install and tighten the retaining nut and
screw.
3.
Connect the wiring harness to the electronic control and IWW modules.
4.
Check the IWW and RABS systems for proper operation.
AEROSTAR
INSPECTION (Aerostar Only)
1.
Locate the RABS electronic control module under the instrument panel. The module is mounted on the driver's side of the engine cover below the
radio and equalizer (or storage bin).
2.
Check the module part number. It is not necessary to remove the module from the vehicle. The module is mounted upside down with the label
facing down.
3.
If the number on the label is F29F-2C018-AD, the module is OK. No further action is required. Release the vehicle.
If the label number is a number other than F29F-2C018-AD, replace the module.
REMOVAL (Aerostar Only)
1.
Disconnect the wiring harness from the anti-lock electronic control module connector by depressing the plastic tab on the connector and pulling
the connector off.
2.
Remove the two nuts that retain the anti-lock electronic control module and anti-shake brace to the instrument panel.
3.
Remove the anti-lock electronic control module from the anti-shake brace. MUTILATE AND SCRAP THE REMOVED INCORRECT
MODULE.
INSTALLATION (Aerostar Only)
1.
Position the correct anti-lock electronic control module on the anti-shake brace.
2.
Position the anti-lock electronic control module and anti-shake brace in the instrument panel. Install and tighten the two retaining nuts.
3.
Connect the wiring harness to the anti-lock electronic control module.
4.
Check the system for proper operation.
F-150-250-350
REMOVAL (F-Series Only)
1.
Locate the RABS electronic control module located in the cab directly behind the glove box.
