F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
2.
Disconnect the wiring harness from the anti-lock electronic control module by depressing the plastic tab on the connector and pulling the
connector off.
3.
Remove the two screws that retain the anti-lock electronic control module to the instrument panel. Remove the module.
INSPECTION (F-Series Only)
1.
Check the module part number. If the number on the label is F3PF-2C018-CA (for single rear wheel) or F3PF-2C018-DA (for dual rear wheel),
the module is OK. Reinstall the module and release the vehicle.
2.
If the label number is other than F3PF-2C018-CA or F3PF-2C018-DA, replace the module. MUTILATE AND SCRAP THE REMOVED
INCORRECT MODULE.
INSTALLATION (F-Series Only)
1.
Place the anti-lock electronic control module in position behind the glove box and install the retaining screws. Tighten the screws to 18-27 in.lb.
(2.1-2.9 N-m).
2.
Connect the wiring harness to the anti-lock electronic control module.
3.
Check the system for proper operation.
ECONOLINE
REMOVAL (Econoline Only)
1.
Locate the RABS electronic control module located in the cab mounted to the instrument panel lower brace behind the passenger trim cover.
2.
Remove the screws that hold the anti-lock electronic control module to the instrument panel lower brace. Pull the anti-lock electronic control
module off the retainer clip assembly.
3.
Disconnect the wiring harness from the anti-lock electronic control module by depressing the plastic tab on the connector and pulling the
connector off.
INSPECTION (Econoline Only)
1.
Check the module part number. If the number on the label is F3UF-2C018-AB (for single rear wheel) or F3UF-2C018-BB (for dual rear wheel),
the module is OK. Reinstall the module and release the vehicle.
2.
If the label number is other than F3UF-2C018-AB or F3UF-2C018-BB, replace the module. MUTILATE AND SCRAP THE REMOVED
INCORRECT MODULE.
INSTALLATION (Econoline Only)
1.
Connect the wiring harness to the anti-lock electronic control module.
2.
Push the anti-lock electronic control module onto the instrument panel lower brace retainer clips and install the retaining screws. Tighten the
screws to 15.1-18.5 in.lb. (1.7-2.1 N-m)
3.
Check the system for proper operation.
Owner Letter
Serial Number: 12345678901234567
June, 1994
Mr. John Sample
123 Main Street
Anywhere, USA 12345
Ford Motor Company is providing a no-charge Service Program, Number 94B38, to owners of certain 1992-1994 F-Series, Econolines, Rangers and
Aerostars.
REASON FOR THIS PROGRAM
An incorrect service replacement rear anti-lock brake system module may have been installed on your vehicle. If the vehicle is equipped with the
incorrect module, adverse braking characteristics and failure of the instrument panel warning light (that indicates a rear anti-lock brake system failure)
may occur.
