F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
^
Frame rail at the steering bolt heads
^
Frame rail at or near the leaf spring mounting brackets
^
Front crossmember where the track bar mounting bracket mounts
If shimmy has been experienced, replace the steering gear sector shaft with repair kit (EOAZ-3575-A) as outlined in the 1991 Light Truck Service
Manual.
Check the steering gear for presence of meshload. With the front wheels off the ground, hold the tire and turn the tire side-to-side slowly. The effort
should increase when turning the tire straight ahead. If no increase in effort is noted, perform the Service Manual procedure as outlined on Page
11-020-06 in Volume 1 of the 1991 Light Truck Service Manual to check and adjust the meshload.
BALL JOINTS OR WORN KING PIN
For proper diagnosis and replacement of king pins and ball joints, refer to the 1991 Light Truck Service Manual, Volume 1, Page 04-00-09.
WHEEL BEARING END PLAY
For proper diagnosis, adjustment or replacement of the wheel bearing, refer to the 1991 Light Truck Service Manual, Volume 1, Pages 04-00-09 and
04-01 A-5.
ALIGNMENT
All alignment adjustments should be measured and set to the recommended specifications as stated in the 1991 Light Truck Service Manual, Volume 1,
Page 04-00-13.
WHEEL/TIRE SIZE AND BALANCE
Compare tire size and wheel size with sizes and pressures on the certification label. Inflate to the specified pressure. Assure correct balance of the front
wheels.
STEERING DAMPER
A steering damper kit should be installed when shimmy is experienced. Install the following Service Kits: F-350 4X4 SRW and DRW vehicles
(E7TZ-3E651-C); F-Super Duty Chassis Cab (F-47) (E8TZ-3E651-B). Steering damper installation sketches are shown in the 1991 Light Truck Service
Manual, Volume 1, Section 04-00, Pages 8 and 10.
