F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
13.
Remove tensioner assembly retaining bolt, then remove tensioner assembly.
14.
Remove power steering pump retaining bolts then position pump rearward out of bracket. Retain bolts for reuse.
15.
Remove A/C-P/S bracket retaining bolts then remove bracket from vehicle. Retain bolts for reuse.
Installation
1.
Install the new A/C-P/S Bracket (19E708) to the left cylinder head and install original retaining bolts. Tighten bolts to 47 N-m (35 ft-lb). Refer to
Figure 1.
2.
Position power steering pump and install original retaining bolts. Tighten bolts to 47 N-m (35 ft-lb). See Figure 1.
3.
Install power steering pump pulley using Steering Pump Pulley Replacer T65P-3A733-C or equivalent so the pulley hub is flush to the end of the
shaft +/- .010 inch. See Figure 2.
CAUTION
Be sure to properly position the tensioner lug into the locating hole of the bracket. Failure to secure the tensioner as outlined may result in damage to
front end accessory drive components.
