F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
4.
Install the tensioner as follows (See Figure 3):
a.
Position the tensioner assembly (6B209) to the A/C-P/S bracket (19E708), with the upper mounting bracket resting on the flange next to the
vacuum pump mounting area.
b.
Tighten the Torx-head bolt to 30 N-m (22 ft-lb) using a T-50 Torx bit; then tighten the bolt an additional 90 degrees.
c.
Secure the upper mounting bracket to the flange with bolts (N606689-S2) and nuts (N620481-S2), with the nuts positioned under the flange.
Tighten bolts to 27 N-m (20 ft-lb).
5.
Position the flanged idler pulley (19A216) to A/C-P/S bracket (19E708). Be sure the cutout in the rear flange is positioned around the body of the
tensioner assembly. Tighten idler pulley bolt to 55 N-m (40 ft-lb). See Figure 4.