F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Fluid - A/T: Service and Repair
With E4OD
FLUID CHANGE
NOTE: No service is required on this transmission under normal use. When under severe oil conditions the transmission oil pan screen assembly should
be replaced, and transmission and torque converter oil should be drained and refilled with oil as specified to proper level every 30,000 miles. If service is
needed proceed as follows:
1. Loosen transmission fluid pan bolts to partially drain fluid.
2. Slowly remove remaining bolts, lower pan and discard old gasket.
3. Drain torque converter by removing drain plug.
4. Reverse procedure to install, noting the following:
a. Install new torque converter drain plug and torque to 18-20 ft lbs.
b. Ensure the new filter and gasket application is correct.
CAUTION: 4WD and 2WD are not interchangeable. Damage may result if wrong filter is installed.
c. Only use MERCON or MERCON V transmission fluid.
d. Install pan bolts and torque to 10-12 ft lbs.
e. Add 6 1/2 quarts of MERCON or MERCON V transmission fluid.
f.
Check fluid and add as necessary.
