F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Fuel Line Coupler: Service and Repair
Removal and Installation
REMOVAL
1. Inspect the push connect fittings for accumulation of dirt. If more than a light coating of dust is present, clean the fitting before disassembly.
2. Some adhesion between the seals in the fitting and the tubing will occur with time. To separate, twist the fitting on the tube, then push and pull the
fitting until it moves freely on the tube.
3. Remove hairpin type retaining clip from fitting by:
a.
Bend the shipping tab downward so that it will clear the body.
b.
Spread the two clip legs approximately 3.2 mm (1/8 inch) each to disengage the body and push the legs into the fitting.
c.
Lightly pull from the triangular end of the clip and work it clear of the tube and fitting.
CAUTION: Do not use any tools.
4. Grasp the fitting and hose assembly and pull in an axial direction to remove the fitting from the steel tube.
5. Once the fitting is removed from the tube end, inspect the fitting and tube for any internal parts that may have been dislodged from the fitting.
INSTALLATION
1. It is recommended that the original clip not be reused. To install the new clip, insert clip into any two adjacent openings with the triangular portion
pointing away from the fitting opening. Install clip to fully engage the body (legs) of hairpin clip locked on outside of body.
2. Before installing fitting on the tube, wipe tube end clean with a cloth. Inspect the fitting to ensure it is free of dirt and/or obstructions.
3. To install the fitting onto the tube, align the fitting and tube axially and push the fitting onto the tube end. When the fitting is engaged, a definite
click will be heard. Pull on fitting to make sure it is fully engaged.
