F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
3. Remove all damaged hose and tube sections.
INSTALLATION
1. Cut a new section of steel tubing to approximately the same length and inside diameter as the section to be replaced. Allow extra length for flaring
the ends of the tubing where required. Square the ends of the cut tubing with a file.
2. Ream the inside edges of the cut tubing with the reamer blade on the tube cutter. Be sure metal chips are removed from inside the tube(s). Double
flare the ends of the cut tubing, as required.
3. Bend the tube section to conform to the contour of the original tube. Cut an ample length of hose to form a coupling between the ends of the fuel
tubes. Connect the hose couplings to the tubing and install the retaining clamps.
4. Position the tube assemblies in the clips. Connect the tubes and check for leaks.
