F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Accelerator Pedal Position Sensor: Service and Repair
Accelerator Pedal Position Sensor
CAUTION: The accelerator pedal assembly is a calibrated unit and must be handled with care.
REMOVAL
1. Disconnect the electrical connectors from the Idle Validation Switch (IVS) and the Accelerator Pedal Position (AP) sensor.
2. remove the bolts holding the accelerator pedal and shaft to the instrument panel,
3. Remove the accelerator pedal and sensor assembly from the instrument panel.
INSTALLATION
1. Position accelerator pedal and sensor assembly to instrument panel and install lower nut hand tight.
2. Install and tighten accelerator pedal and sensor assembly nuts to 22-28 Nm (17-20 ft lb).
3. Connect the electrical connectors to the IVS and AP sensors.
