ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

All Technical Service Bulletins for Powertrain Control Module:|99-4-3 > < A/T - Harsh Shifts/Trouble Code 62/TCIL Lamp Flashes|Page 212
Page 1
background image

Powertrain Control Module: All Technical Service Bulletins
Engine Control - Reduced Power, No Start

Article No.
03-21-3

10/06/03

DRIVEABILITY - REDUCED POWER - NO START - 7.3L
D.I. TURBO - IDM MODULE - NO DIAGNOSTIC
TROUBLE CODES

FORD: 
1994-1997 F SUPER DUTY, F-250, F-350 
1997 ECONOLINE

Article 95-6-13 is being republished in its entirety as part of a consolidated 7.3L diagnostic aid booklet.

ISSUE

A "no-start" or "reduced power" condition may occur intermittently on some vehicles. This may be caused by a short in the injector circuits or the IDM
module.

ACTION

Follow the diagnostics listed in the Diagnostic Guide and refer to the following Service Procedure.

SERVICE PROCEDURE

1.

If after completion of all the steps in the Power Stroke 7.3L (DI Turbo) Diesel Diagnostic Guide, you are unable to pinpoint the cause of the
concern, proceed with the following steps.

2.

Disconnect the IDM Module connector and using a DVOM, measure the resistance between the injector circuits to ground. If it is less than 5 ohms
resistance, repair the short in the circuit and retest.

3.

If the concern still exists, replace the IDM module.

PARTS BLOCK

OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 95-6-13
WARRANTY STATUS: INFORMATION ONLY

Disclaimer

All Technical Service Bulletins for Powertrain Control Module:|99-4-3 > < A/T - Harsh Shifts/Trouble Code 62/TCIL Lamp Flashes|Page 212