F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
NOTE: Install snap ring, making sure it is seating in the groove. If new composition plates are to be used, they should be soaked in transmission
fluid for 15 minutes prior to assembly.
Forward Clutch Snap Ring Clearance Inspection
5. With feeler gauge, check clearance between snap ring and pressure plate. Downward pressure on plate should be maintained when making this
check. Clearance should be 0.021-0.046 inch. If not, selective thickness snap rings are available in thicknesses of 0.056-0.060 inch, 0.065-0.069
inch, 0.074-0.078 inch, 0.083-0.087 inch, 0.092-0.096 inch, 0.110-0.114 inch and 0.128-0.132 inch. Install correct thickness snap ring and
recheck clearance.
With E4OD
DISASSEMBLE
Exploded View Of Forward Clutch
NOTE: Refer to the Exploded View Of Forward Clutch image when performing the following procedure.
