F 350 4WD Super Duty V10-6.8L (2002)
^
The seat backrest pivot bolt shaft must be inserted into the cover standoff.
CAUTION: Bend the side shield slightly to insure the shield is not scratched by the recliner lever.
3. Push the rearward lower corner of the side shield to engage the metal retaining clip.
4. Position the lumbar adjuster control and install the two mounting screws. Install the adjuster knob.
5. Position the seat back recliner lever cover and install the screw.
6. Install the front seat.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS,
NOTES AND INSTRUCTIONS IN THE FRONT SEAT REMOVAL AND INSTALLATION PROCEDURE.
7. Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS,
NOTES AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION/REACTIVATION
PROCEDURE.
8. With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
9. Check the active restraints for correct operation.
