F 350 4WD Super Duty V10-6.8L (2002)
Alignment: Service and Repair
Lean Correction - Front, F-250, F-350, 4X4 and F-450, F-550
Lean Correction - Front, F-250, F-350, 4x4 and F-450, F-550
NOTE: Front side lean can be adjusted approximately 10 mm (3/8 inch) by installing shim D7TZ-5742-A on the low side. A vehicle that is low at
the front can be raised by installing shims at both sides.
Raise and support the vehicle.
2. Support the axle.
3. Remove and discard the four nuts and two U-bolts.
4. Separate the front axle from the springs.
5. Turn the shim so the recess is facing upward.
